-13e587be-822d-4fcf-825e-78c947324e4b.png){kind=small}
Pro Memory Controller Displaying "Hot" messageUpdated a month ago
Q: Help! There's an "Hot" message on my Pro Memory Controller.
Step 1: Unplugging all cables (to the Pro Memory Controller)
- Two cables connecting from the motor legs of the Pro Frame
- One cable connecting to the power adaptor
Step 2: Wait for 18 minutes
Step 3: Once the error code "HOT" disappears, you may proceed
Step 4: Re-plug all connecting cables
- Two cables connecting from the motor legs of the Pro Frame
- One cable connecting to the power adaptor
Step 5 : External Check
- Ensure there are no obstructions to the desk that may hinder its up-down movement. (no objects below the desk e.g. drawer/cabinet, or cables at the edges tugging on the desk).
Step 6 : Conduct a reset for the table
1. Press and hold the "DOWN" button until the table is lowered.
2. Once the table starts lowering, do not release the button.
3. Continue holding until the table reaches the lowest point and slightly rises again (a slight 'bounce').
Once you observe this “bounce" and a beep from the buzzer, the table has been successfully reset.
We have attached a video for your reference.
IF the issue persists
If the error message continues after completing the steps above, please share the video recording and the production date on the table frame that is located at the leg with us.
This will help us identify the root cause and assist with warranty claim processing if required.